History

Ryan ebb512db82 Debounce defines cleanup (#19742 ) * Clean up `DEBOUNCE` in config.h, 0-9 * Clean up `DEBOUNCE` in config.h, A * Clean up `DEBOUNCE` in config.h, B * Clean up `DEBOUNCE` in config.h, C * Clean up `DEBOUNCE` in config.h, D * Clean up `DEBOUNCE` in config.h, E * Clean up `DEBOUNCE` in config.h, F * Clean up `DEBOUNCE` in config.h, G * Clean up `DEBOUNCE` in config.h, H * Clean up `DEBOUNCE` in config.h, handwired * Clean up `DEBOUNCE` in config.h, I * Clean up `DEBOUNCE` in config.h, J * Clean up `DEBOUNCE` in config.h, K * Clean up `DEBOUNCE` in config.h, L * Clean up `DEBOUNCE` in config.h, M * Clean up `DEBOUNCE` in config.h, N * Clean up `DEBOUNCE` in config.h, O * Clean up `DEBOUNCE` in config.h, P * Clean up `DEBOUNCE` in config.h, Q * Clean up `DEBOUNCE` in config.h, R * Clean up `DEBOUNCE` in config.h, S * Clean up `DEBOUNCE` in config.h, T * Clean up `DEBOUNCE` in config.h, U * Clean up `DEBOUNCE` in config.h, V * Clean up `DEBOUNCE` in config.h, W * Clean up `DEBOUNCE` in config.h, X * Clean up `DEBOUNCE` in config.h, Y * Clean up `DEBOUNCE` in config.h, Z * Remove default debounce from info.json * Migrate non-default debounce to info.json		2023-02-03 19:19:58 +00:00
..
config.h	Debounce defines cleanup (#19742 )	2023-02-03 19:19:58 +00:00
overnumpad_1xb.c	overnumpad controller: Add support for turning off solenoid enable in low power. (#15021 )	2021-11-02 20:49:23 +11:00
overnumpad_1xb.h
readme.md
rules.mk	Migrate `LAYOUTS` to data driven (#19541 )	2023-01-10 02:48:20 +00:00

readme.md

unicomp/classic_ultracl_pre_2013/overnumpad_1xb

Will support the following Unicomp Classic and Ultra Classic keyboards:

104-key ANSI and 105-key ISO keyboards with post-2013 bottom row are supported.
Keyboard Maintainer: Purdea Andrei
Hardware Supported: OverNumpad controller v1.Xb
Hardware Availability:
- controller
- keyboard

To place the keyboard into bootloader mode in order to flash it, hold the ESC key while plugging the board in. It's possible to make this feature not work, by flashing the wrong firmware onto the keyboard. If that happens, open up the keyboard, and press the RST&PROG button to enter bootloader mode.

Make example for this keyboard (after setting up your build environment):

make unicomp/classic_ultracl_pre_2013/overnumpad_1xb:default

Flashing example for this keyboard:

make unicomp/classic_ultracl_pre_2013/overnumpad_1xb:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.