qmk_firmware/keyboards/mechlovin/zed60
2023-03-23 21:38:01 +11:00
..
keymaps [Keyboard] Add Zed60 PCB (#17304) 2022-07-17 09:24:28 -07:00
config.h Remove RGB_DI_PIN ifdefs (#20218) 2023-03-23 21:38:01 +11:00
halconf.h [Keyboard] Add Zed60 PCB (#17304) 2022-07-17 09:24:28 -07:00
info.json Move matrix config to info.json, part 7 (#20020) 2023-03-11 00:39:56 +11:00
mcuconf.h [Keyboard] Add Zed60 PCB (#17304) 2022-07-17 09:24:28 -07:00
readme.md RESET -> QK_BOOT keyboard readme (#18110) 2022-08-20 11:34:17 +01:00
rules.mk Migrate MCU and BOOTLOADER to data-driven (#19529) 2023-02-08 18:41:46 +11:00
zed60.h [Keyboard] Add ISO layout support for Zed60 PCB (#19204) 2022-12-04 20:47:56 +00:00

zed60

zed60

Zed60 PCB, 60% keyboard PCB.

  • Keyboard Maintainer: Mechlovin'
  • Hardware Supported: Zed60, APM32F103
  • Hardware Availability: Mechlovin'

Make example for this keyboard (after setting up your build environment):

make mechlovin/zed60:default

Flashing example for this keyboard:

make mechlovin/zed60:default:flash

Bootloader

Enter the bootloader in 4 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available
  • Bootloader: Hold down the key at (0,13) in the matrix (Backspace) and plug in the keyboard

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.