fcb5653411
* Switch Quefrency from flaky I2C back to serial * Lower mouse wheel speed on Quefrency slightly * Migrate common settings to userspace * Enable Bootmagic Lite for consistent reset to bootloader. * Turn off some undesired features across all keyboards. * Remove EEPROM reset keybinding from all keyboards since Bootmagic Lite also does an EEPROM reset. * Set backlight and underglow increments consistently across all keyboards since lots of them like to override the deafults. * Set mouse keys consistently across all keyboards. * Update function layer keymap images
23 lines
858 B
C
23 lines
858 B
C
#pragma once
|
|
|
|
/*
|
|
* I2C seems to randomly drop keystrokes. Not sure why. It seems a bit like
|
|
* https://github.com/qmk/qmk_firmware/issues/5037, but that issue is closed,
|
|
* and our problems happen even with underglow disabled.
|
|
*
|
|
* This issue occurs with multiple TRRS cables of different lengths from
|
|
* different companies, so it's most likely not a cable issue. It may be that
|
|
* we are running into issues with long I2C runs, in which case stronger
|
|
* pull-up resistors might help:
|
|
* https://hackaday.com/2017/02/08/taking-the-leap-off-board-an-introduction-to-i2c-over-long-wires/.
|
|
* For now, just don't use I2C.
|
|
*/
|
|
#define USE_SERIAL
|
|
|
|
/* Use an extra LED on the right side since it's wider on the 65% PCB. */
|
|
#undef RGBLED_NUM
|
|
#define RGBLED_NUM 17
|
|
|
|
/* Set up RGB lighting so it works with either side as master. */
|
|
#define RGBLED_SPLIT { 8, 9 }
|