qmk_firmware/keyboards/redox/rev1/proton_c/config.h
xerootg 1111ff604d
[Keyboard] Add the proton c as a controller for the redox (#16106)
Co-authored-by: Sergey Vlasov <sigprof@gmail.com>
Co-authored-by: xerootg <xerootg@github.com>
2022-01-31 11:40:13 -08:00

67 lines
2.3 KiB
C

// Copyright 2022 xerootg
// SPDX-License-Identifier: GPL-2.0-or-later
#pragma once
#include "config_common.h"
/* USB Device descriptor parameter */
#undef DEVICE_VER
#define DEVICE_VER 0x0101 // added 1 for the rev1 + proton c
// wiring of each half
#undef MATRIX_ROW_PINS
#define MATRIX_ROW_PINS { B5, B3, B2, B1, B0 }
#undef MATRIX_COL_PINS
#define MATRIX_COL_PINS { A1, A0, B8, B13, B14, B15, B9 }
// //we are using hardware serial, so lets undef the softserial used otherwise
/* serial.c configuration for split keyboard */
#define SERIAL_USART_FULL_DUPLEX // Enable full duplex operation mode.
/*
Because the rev1 config defines SOFT_SERIAL_PIN, we need to undef it, redefine it, and also assign
it to avoid a redefine error.
*/
#undef SOFT_SERIAL_PIN
#define SOFT_SERIAL_PIN B6 // USART TX pin
#define SERIAL_USART_RX_PIN B7 // USART RX pin
#define SERIAL_USART_TX_PIN SOFT_SERIAL_PIN // USART TX pin
#define SERIAL_USART_PIN_SWAP // Swap TX and RX pins if keyboard is master halve.
// Check if this feature is necessary with your keyboard design and available on the mcu.
#define SELECT_SOFT_SERIAL_SPEED 1 // or 0, 2, 3, 4, 5
// 0: 460800 baud
// 1: 230400 baud (default)
// 2: 115200 baud
// 3: 57600 baud
// 4: 38400 baud
// 5: 19200 baud
#define SERIAL_USART_DRIVER SD1 // USART driver of TX and RX pin. default: SD1
#define SERIAL_USART_TX_PAL_MODE 7 // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 7
#define SERIAL_USART_RX_PAL_MODE 7 // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 7
#define SERIAL_USART_TIMEOUT 20 // USART driver timeout. default 20
/* ws2812 RGB LED */
#undef RGB_DI_PIN
#define RGB_DI_PIN A9
/*
* Feature disable options
* These options are also useful to firmware size reduction.
*/
/* disable debug print */
// #define NO_DEBUG
/* disable print */
// #define NO_PRINT
/* disable action features */
//#define NO_ACTION_LAYER
//#define NO_ACTION_TAPPING
//#define NO_ACTION_ONESHOT
//#define NO_ACTION_MACRO
//#define NO_ACTION_FUNCTION