qmk_firmware/keyboards/mechlovin/zed65/rev1
2023-07-08 01:16:19 -07:00
..
keymaps Mechlovin Zed65 rev1 Develop Touch-Up (#21476) 2023-07-08 01:16:19 -07:00
config.h [Keyboard] Add the Zed65 rev.1 PCB (#21043) 2023-06-03 01:03:45 -06:00
halconf.h [Keyboard] Add the Zed65 rev.1 PCB (#21043) 2023-06-03 01:03:45 -06:00
info.json Mechlovin Zed65 rev1 Develop Touch-Up (#21476) 2023-07-08 01:16:19 -07:00
matrix_diagram.md Mechlovin Zed65 rev1 Touch-Up (#21373) 2023-06-24 19:54:23 +01:00
mcuconf.h [Keyboard] Add the Zed65 rev.1 PCB (#21043) 2023-06-03 01:03:45 -06:00
readme.md [Keyboard] Add the Zed65 rev.1 PCB (#21043) 2023-06-03 01:03:45 -06:00
rules.mk [Keyboard] Add the Zed65 rev.1 PCB (#21043) 2023-06-03 01:03:45 -06:00

zed65

Zed65

A 65% PCB with centered USB and JST-SH support, using APM32F103.

Make example for this keyboard (after setting up your build environment):

make mechlovin/zed65/rev1

Flashing example for this keyboard:

make mechlovin/zed65/rev1:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 4 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Bootloader reset: Hold down the key at (0,13) in the matrix (usually the Back Space) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available